F) Ending The Run - Reely SEA Aqua Passion Bedienungsanleitung

Never drive with a water cooling that is clogged or non-functional because of bent hoses.
Also observe the rudder slots (figure 2, item 5). These slots are the water inlet of the water cooling. For the water
cooling system to work, it must be free of contamination at all times. The drive components may otherwise overheat
and be damaged. Loss of guarantee/warranty!
Carefully and horizontally put the model on the water. Ensure that the rudder system as well as the ship's propeller has
no ground contact and can turn freely.
Carefully pull the throttle lever towards the handle. The model starts to drive forward. Turning the remote control
steering wheel to the left or right will cause your model to turn in the respective direction.
Driving time is approx. 15 to 18 minutes with a full tank, depending on driving style. Terminate the trip in time and return
to the shore. Switch off the motor via the button at the rear of the boat. Open the hull deck and switch off the receiver
first and then the transmitter.
After a trip, the motor and muffler must cool off to ambience temperature. Therefore, make a break of approx.
5 to 10 minutes before the next trip. The hull deck should remain disassembled for better cooling.
Check whether any water has entered the model. Ingressing water must be removed at once. Observe that the water
does not enter the remote control or drive parts during emptying.
Low water volumes entering (max. approx. 100 ml per trip) is normal; it must be emptied after every operation.
Practical advice:
If water ingression increases continually, the grease has usually been flushed from the drive shaft. In this
case, the shaft must be removed and re-lubricated. Observe the notes in chapter „Maintenance and Care"
for this.

f) Ending the Run

To stop driving, proceed as follows:
• Return to land and let go of the throttle/brake lever at the transmitter so that it returns to neutral position.
• Deactivate the motor via the trimming function when the boat is close enough. You may also move the boat slowly to
the bank and deactivate the motor via the outer button in the rear area of the boat body.
Never touch the ship propeller or the drive mechanism, and make sure you do not move the throttle/brake
lever at the transmitter! Hold the boat well!
• Switch off the receiver power supply.
• Switch off the transmitter last.
Attention!
The motor and drive parts (e.g. exhaust) grow very hot in operation! Do not touch these parts immediately
after operation. Danger of burns!
36