G) Angle Of Attack Of The Drive Shaft; H) Boat Rack Installation; Operating The Model; A) Fuelling Up The Model - Reely SEA Aqua Passion Bedienungsanleitung

g) Angle of Attack of the Drive Shaft

Your model has a holder for the drive shaft at the tail (figure 6, item 3). Loosening the screw permits adjustment of the
drive shaft's angle of attack slightly to optimise sliding of the model.
The model sliding properties depend on many factors. For example, the weight and installation site of the
drive battery and/or the properties of the water surface (many or few waves) influence the model sliding
properties. Therefore, these operating instructions can to offer specific setting information. You need to
perform operation tests to find the best settings.
h) Installing the Boat Stand
The scope of delivery includes a boat rack of wood
that has to be assembled and glued together first.
Build the boat rack of the four wood parts as shown
in figure 3.
The side parts (figure 3, item 1) must be built so that
the wide side points down.
The side parts are attached into the long parts (figure
3, item 2).
Glue the wood parts on with a drop of viscous in-
stant adhesive or some 5-minute epoxy glue.


9. Operating the Model

a) Fuelling Up the Model

Open the body cover.
Open the tank lid and fill the tank with a two-stroke mixture (mixing ratio 1:25). Use only high-quality bio-degradable
two-stroke oil and Super fuel (Super Plus) for the mixture.
Two-stroke mixture with „E10" fuel or a mixture with a lower oil share must not be used. Motor damage
threatens at non-observance; loss of guarantee/warranty!
The boat always must be fuelled up on land so that no fuel can enter the body of water.
32
Figure 3