Operating Elements & Connections; Front Panel (Xpa 350/700/1000/1200/1800/2700); Rear Panel (Xpa 350/700/1000/1200) - Omnitronic XPA 3004 Bedienungsanleitung

4
OPERATING ELEMENTS & CONNECTIONS

Front Panel (XPA 350/700/1000/1200/1800/2700)

No. Element
1 Display LEDs
2 POWER switch
3 CH-1 and CH-2

Rear Panel (XPA 350/700/1000/1200)

No. Element
4 Voltage selector switch
5 Power input with f use holder
6 Speaker connectors
7 Speaker connector
8 Input jacks
9 Selector switch limiter
10 Selector switch operating mode
11 Selector switch ground lif t
Function
• CLIP: ov erload
• 0dB, -15dB, -20dB -30dB: input lev el indication
• PROTECT: protectiv e circuit active
• POWER: power indication
• BRIDGED = bridge mode
Switches the amplif ier on an of f
Lev el controls channel 1 and channel 2
Function
Switches between 115 V ad 230 V
• Used to plug in the supplied power cord
• Only replace the f use when the dev ice is disconnected from mains. Only
use f uses of the same rating and power. The correct f use value is
specif ied on the rear panel.
Speaker jacks and screw terminals f or channel 1 and 2
Speaker jack f or bridge operation
Optionally XLR or 6.3 mm jack f or channel 1 and 2 f or connecting units
with line lev el
OFF = limiter is switched of f, ON = limiter is switched on
ST = stereo operation, BRI = bridge operation
LIFT = signal ground and housing ground are separated,
GND = signal ground and housing ground are connected
24