Bridge Operation (Xpa 3004) - Omnitronic XPA 3004 Bedienungsanleitung

Bridge Operation (XPA 3004)

In bridge mode, channels 1 and 2 and channels 3 and 4 are bridged and therefore provide higher power than
a single channel. Thus, the voltage at the outputs of channel 1 and channel 3 is doubled and subsequently
the output impedance. A signal at the input of channel 2 and channel 4 is ignored. The volume is adjusted
together for both outputs with the control of channel 1 and channel 3. Set the operating mode selector switch
to BRI.
Fig. 9 Wiring in bridge mode
31