Operating Elements And Connections; Front Panel - Omnitronic MPZ 180.6 Bedienungsanleitung

3 Operating Elements and Connections

This user manual describes the MPZ-500.6 as a reference. The other models are similar in construction.

Front panel

Power on/off
1
Turns the unit on and off. The power indicator lights
up when the unit is powered on.
Control LEVEL
2
Master control for the total volume.
Tone controls
3
2-way tone control for the output signal: bass and
treble.
Controls MIC 1 to 3
4
Volume controls for the microphone inputs MIC 1 to
3.
Input PRIORITY MIC 1
5
• Unbalanced combo connector (XLR/6.3 mm jack)
for connecting a dynamic microphone.
• This input has priority: In case of an
announcement via this microphone channel the
level of the other signal sources is attenuated–
depending on the rear control PRIORITY LEVEL–
thereby increasing the intelligibility of the
announcement.
LED level meter for the output signal
6
Buttons Z 1 to 6 with control LEDs
7
For switching the PA zones on and off. With a zone
activated the corresponding LED lights up.
Controls LINE 1 to 3
8
Volume controls for the line inputs LINE 1 to 3.
Button CHIME
9
For releasing the chime.
LED FAULT
10
Lights up with activated protective circuit:
• for a few seconds after switching-on unit the
speaker outputs are ready for operation
• during operation when the protective circuit has
switched off the speakers in case of a defect
Power LED
11
17 • EN