Operating Elements And Connections - Omnitronic MP Series Bedienungsanleitung

5.2 Operating elements and connections

This user manual describes the MP-250 as a reference. The other models are similar in construction.
1
Power on/off
Turns the unit on and off. The power indicator lights
up when the unit is powered on.
2
Control LEVEL
Master control for the total volume.
3
Tone controls
2-way tone control for the output signal: bass and
treble.
4
Controls MIC 1 to 3
Volume controls for the microphone inputs MIC 1 to
3.
5
Input PRIORITY MIC 3
• 6.3 mm jack for
microphone.
• This input has priority:
announcement via this microphone channel the
level of the other signal sources is attenuated–
depending on the rear control PRIORITY LEVEL–
thereby increasing
announcement.
connecting a dynamic
In case of
the intelligibility of
6
LED level meter for the output signal
7
Controls LINE 1 to 3
Volume controls for the line inputs LINE 1 to 3.
8
Button CHIME
For releasing the chime.
9
LED FAULT
Lights up with activated protective circuit:
• for a few seconds after switching-on unit the
speaker outputs are ready for operation
• during operation when the protective circuit has
switched off the speakers in case of a defect
10
Power LED
an
the
22/28 00053678.DOC, Version 1.3