Operating Elements And Connections - Omnitronic XDA-1204 Bedienungsanleitung

3 Operating Elements and Connections

XDA-1204
No. Element
1 Power switch
2 Power indicator
3 Level controls
4 SIG status indicator
5 CLIP status indicator
6 BRG / 100V status indicator
7 XLR input jacks CH 1-4 IN
CH 1 BRIDGE / CH 3 BRIDGE
8 Plug-in screw terminals IN
9 Terminals LINK OUT
10 Selector switch
11 Speaker jacks CH 1-4 OUT
12 Plug-in screw terminals CH 1-4 OUT
1+/2+ / 3+/4+
13 AC input with fuse holder
Function
Turns the amplifier on and off
Indicates that the amplifier is switched on
Independent level controls for each PA zone
Lights up when a specific signal level has been reached
Lights up in case of overload
Lights up in bridge or 100 V mode
Balanced inputs to connect signal sources with line level;
use the CH 1 and CH 3 jacks in bridge mode
Balanced inputs to connect signal sources with line level
Feed-through outputs for connection of a further amplifier
• BRIDGE/100V: Bridge operation with double power / 100 V operation
• STEREO: the channels are operated independently
• PARALLEL: the channel pairs are switched in parallel
To connect speakers for each PA zone
To connect speakers for each PA zone;
to connect speakers in bridge or 100 V mode
Used to plug in the supplied power cord;
only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse value is specified
on the rear panel.
14 • EN