Assembling The Device; Use - Cleanmaxx VC9387S-7 Gebrauchsanleitung

EN
Attaching the Handle to the Device
You will need a cross-head screwdriver.
1. Take the handle (14) and unscrew both screws from the bottom ends of the handle.
2. Insert the handle onto the adapter of the centre piece (13) and screw the screws back
into the boreholes.

Assembling the Device

Use

Preparing the Carpet
1. Thoroughly vacuum clean the carpet to be treated with a vacuum cleaner. Use a
brush adapter for this (if possible).
2. If possible, remove all furniture from the carpet. Place a plastic tarp under or around
the legs of large pieces of furniture that can't be moved aside and only remove the
tarp once the carpet is completely dry after cleaning. Otherwise the wet carpet could
damage the legs.
3. Check the carpet's colour-fastness. Dip a piece of white fabric in the enclosed
cleaning solution and carefully rub it on a hidden part of the carpet. If the white fabric
does not discolour, you can clean the carpet with the device. For multicoloured
carpets, test every colour for colour-fastness.
16
1. Lay the dirty water reservoir (11) in the base (10) of the
device and fold down the handle of the reservoir (12) until
it audibly engages.
2. Insert the fresh water reservoir (6) into the centre
piece (13). First insert the valve into the round depression
on the backside of the device and then press the top of the
reservoir against the centre piece until it audibly engages.
3. Turn the lower hooks of the cable reel (3) downward and
wrap the mains cable around both hooks of the cable reel.
4. Your carpet cleaner is now ready for operation.