Prior To Fi Rst Use; Unpacking The Product Contents; Assembling The Device - Cleanmaxx VC9388 - Z 05493 Gebrauchsanleitung

Prior to fi rst use
Before you use the device, you must do the following:
• unpack the product contents,
• assemble the device.

Unpacking the product contents

ATTENTION!
❐ Danger of suffocation! Keep children and pets away from the packaging.!
Unpack all parts and make sure that the product contents are complete (see chapter "Product
contents") and check for any damages from transport. If you identify damages to the com-
ponents, do not use the device (!), instead contact our customer service centre (see chapter
"Customer service").

Assembling the device

For assembly, you will also need a star-headed screwdriver.
Align the
holes
screwing
screwing screwing
1. The fresh water tank (3) has already been installed in the mid-
section. Remove it before assembly by fi rst depressing the re-
lease button (2) and then pulling it out.Mount the midsection on
the main unit as shown.
2. Insert the handle in the opening on the midsection and align it so
that the curved end of the handle is on the back of the device.
The handle will lock into place in the right position.
3. Screw the 3 enclosed screws into the threading on the back of
the midsection (see fi gure) and tighten them with a star-headed
screwdriver.
4. Turn the hook of the upper cord bracket up.
5. Insert the connecting piece on the bottom of the fresh water
tank in the ring on the bottom of the midsection. Push the top
part of the tank against the midsection until the catch audibly
locks into place.
Carpet Cleaner.
18
You have now assembled your "cleanmaxx"