Using The Camera In Time-Lapse Mode (Tls) - Conrad 596113 Bedienungsanleitung

Recording video
• Push the M key once.
• If."VIDEO".does.not.flash.on.the.LC.display,.push.the.
• Push the OK.key.to.confirm..Then.push.the.M key to leave the menu.
30. seconds. after. making. the. setting,. the. laser. beam. begins. to. flash. and. starts. the.
countdown..The.laser.beam.turns.off.after.approx..60.seconds.
You. have. 1. minute. to. exit. the. camera's. detection. area..After. 1. minute,. the. camera.
switches.either.to.image.or.video.mode,.depending.on.the.setting..Then,.the.camera.
will.pause.for.an.idle.time.between.5.seconds.and.59.minutes.59.seconds,.depending.
on the setting.
The.time.between.motion.detection.and.the.time.when.the.camera.releases.the.shutter.
can.depend.on.various.factors.such.as.lighting.conditions,.program.settings.or.battery.
status.and.may.therefore.vary.from.the.settings..The.infrared.LEDs.are.activated.only.
in very poor lighting conditions.
d) Using the camera in time-lapse mode (TLS)
• Fasten.the.camera.to.a.tree,.a.wall.or.another.sturdy.object.using.the.provided.fastening.strap.(26).
or.the.provided.wall.bracket.(27).
• Open.the.bottom.cover.(7).and.switch.the.TEST OFF CAM PSET switch to CAM or PSET position.
Set.the.camera.to.TLS.mode.
• Make.sure.the.camera.is.in.TLS.mode..See.the.segment."Setting.up.and.programming.the.
camera".if.you.are.unsure.
• 30.seconds.after.making.the.settings,.the.laser.beam.begins.to.flash.and.starts.the.countdown.
(approx..60.seconds)..Use.the.laser.beam.to.align.the.camera.to.the.detection.area.if.necessary..
• After.the.laser.beam.stops,.you.have.approx..1.minute.to.leave.the.camera's.detection.area..Then.
the camera is active.
key.to.switch.to."VIDEO".mode.
59