A) Laser Function; B) Setting Camera Mode Cam - Conrad 596113 Bedienungsanleitung

If you choose the preset PSET,.the.camera.runs.in.PIR.mode..Time-lapse.mode.(TLS).
will not work then.

a) Laser function

Warning
Do not point the laser beam opening at yourself or other persons or animals when
the. laser. is. activated.. Heed. all. information. on. laser. beams. in. the. segment. "Safety.
instructions".
• The.laser.has.two.functions..It.can.be.used.to.align.the.camera.and.as.a.countdown.after.the.
camera was activated.
• Switch the TEST OFF CAM PSET switch to TEST.position..The.LC.display.shows."tESt"..Point.the.
laser.beam.opening.at.the.area.you.wish.to.record..The.laser.beam.is.active.and.you.can.align.the.
camera using the red laser point as a reference.
• Switch the TEST OFF CAM PSET switch to OFF position to turn off the laser beam after aligning
the camera.
• After.activating.the.camera.for.recording,.the.laser.beam.appears.after.approx..30.seconds.so.you.
can.check.the.camera's.alignment.once.again..The.laser.beam.flashes.for.approx..60.seconds..
The.laser.beam.now.also.acts.as.a.countdown..After.the.60.seconds.run.down,.you.have.approx..
1.minute.to.leave.the.detection.area..The.camera.is.then.active.

b) Setting camera mode CAM

• Switch the TEST OFF CAM PSET switch to CAM position..The.display.shows."CAM".
• Push the M.key.once.within.30.seconds.to.switch.to.the.setting.mode.for.program.selection..PIR.or.
TLS.flashes.on.the.LC.display..
• Push the / .keys.to.select.PIR.mode.(motion.detector).
• Push the OK.key.to.confirm.the.selection..Push.the.M key to leave the menu.
50
T-O.(time.out).=.idle.time
30 seconds