H) Setting Time-Lapse Mode - Conrad 596113 Bedienungsanleitung

h) Setting time-lapse mode

The.basic.setting.for.time-lapse.mode.is.set.from.17:00.to.07:00.on.the.following.day.(5.pm.to.7.am)..
When.the.camera.is.in.time-lapse.mode.(TLS),.the.time-lapse.settings.are.used..When.the.camera.is.
not.in.time-lapse.mode,.the.settings.for.PIR.mode.are.used.
You. can. program. the. time-lapse. mode. for. a. preset. time,. such. as. 19:00. to. 07:00. (7. pm. to. 7. am)..
Then,.you.can.set.the.intervals.in.which.single.frames.or.photo.bursts.are.taken..Video.function.is.
not.available.in.time-lapse.mode..The.camera.runs.in.time-lapse.mode.until.the.setting.is.changed.
manually.
• Switch the TEST OFF CAM PSET switch to CAM position..The.display.shows."CAM".
• Push the M key once within 30 seconds to switch to the setting mode for program selection.
• "PIR".flashes.on.the.LC.display..Push.the.
"TLS".
• "T".flashes.on.the.LC.display,.as.well.as."S-88:88".(S.=.start,.88:88.=.time.in.HH:MM)..Push.the.
OK key once to set the start time.
• The.minutes.flash.on.the.LC.display..Push.the.
increments of 1 minute. Push the OK.key.to.confirm.the.selection.
• The.hours.flash.on.the.LC.display..Push.the.
increments of 1 hour. Push the OK.key.to.confirm.the.start.time.and.to.set.the.turn-off.time.
• "T".flashes.on.the.LC.display,.as.well.as."E-88:88".(E.=.end,.88:88.=.time.in.HH:MM)..Follow.the.
steps for setting the start time to set the minutes and hours.
• Push the M key to leave the menu.
54
key.to.switch.to."TLS"..Push.the.OK.key.to.confirm.
/ keys to set the minutes from 0 to 59 in
/ keys to set the hours from 0 to 23 in