Dust/Chip Extraction - Bosch 0 607 350 198 Originalbetriebsanleitung

OBJ_BUCH-1326-001.book Page 23 Monday, October 11, 2010 10:32 AM
Sanding disc Material
– All wooden materi-
als (e.g., hard-
wood, softwood,
chipboard, building
board)
Red quality
– Metal materials
– Masonry, stone
– Marble
– Granite
– Ceramic
– Glass
Black quality
– Plexiglas
– Automotive paint
– Corian®
– Varicor®
Sanding Plate Selection
Depending on application, the air tool can be
equipped with sanding plates of varying hardness:
– Soft sanding plates: Suitable for polishing and
sensitive sanding, incl. on convex surfaces.
– Medium sanding plates: Suitable for all sand-
ing work; universally usable.
– Hard sanding plates: Suitable for high sand-
ing capacity on level surfaces.
Replacing the Sanding Plate
Note: Replace a damaged sanding plate 9 imme-
diately.
– Pull off the sanding sheet 10.
– Insert open-end wrench 7 under the height-ad-
justable extraction hood 6 and hold the sander
spindle in place with the open-end wrench.
– Unscrew the sanding plate 9 from of the
grinder spindle by turning counterclockwise.
Remove the washer 8, place it on the new
sanding plate and screw it together with the
washer onto the grinder spindle, turning
clockwise.
Bosch Power Tools
Application
For coarse sanding, e.g. of rough,
unplaned beams and boards
For face sanding and planing small
irregularities
For finish and fine sanding of wood
For pre-sanding
For shaping and braking edges
For final sanding and forming
For polish-sanding and rounding off
edges
Type 0 607 350 199|... 200
– The second washer 8 can be used additional-
ly so that the random orbit sander does not
adhere to the workpiece when the dust ex-
traction is activated.

Dust/Chip Extraction

Dusts from materials such as lead-contain-
ing coatings, some wood types, minerals
and metal can be harmful to one's health
and cause allergic reactions, lead to respi-
ratory infections and/or cancer. Materials
containing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
English | 23
Grain size
coarse 40
60
medium 80
100
120
fine 180
240
320
400
coarse 60
medium 80
100
120
fine 180
240
320
400
Very fine 600
1200
3 609 929 C02 | (11.10.10)