Fault Rectifi Cation - Silvercrest SKM 500 B1 Bedienungsanleitung

GB
Fault rectifi cation
80
4) Slide the cutting knife t with the knife guard d fi tted and the kneading
knife r over the drive shaft i onto the emulsifying disc 4.
5) Place the drive shaft adapter z and 2 disks (e.g. cutting w and shredding
disk 0) at the side next to the drive shaft i in the mixing bowl u.
6) Place the disk adapter e with the disk fi tted onto the drive shaft i.
7) Close the lid 3 and slide the pusher 1 into the fi lling shaft 2.
DEFECT
The plug is not
connected.
The appliance is not
The appliance
correctly assembled
does not work.
and engaged.
The appliance is
defective.
The lid 3 of the
appliance may have
become loose when
The appliance
processing hard
stops suddenly.
ingredients.
The appliance is
defective.
The motor runs, but
The drive shaft i is
the accessory parts
not inserted properly.
do not rotate.
CAUSE
Insert the plug into a mains
power socket.
Check the assembly of the
appliance and ensure that all
marks are correctly aligned.
In this case, contact the
Customer Services.
Replace the lid 3.
In this case, contact the
Customer Services.
Check the assembly of the
drive shaft i.
SOLUTION
SKM 500 B1