♦
Press the ON/OFF button
charging process .
♦
During the charging process, the current Power Bank
charge level is shown via the charge level LEDs
(see table in section entitled Checking the charge level) .
♦
Press the ON/OFF button
charging process and switch off the power bank .
The charge level LEDs
♦
Disconnecting the corresponding plug from the mobile
device .
Troubleshooting
The power bank does not charge.
♦
The connection may be faulty . Check the connection .
A connected device does not charge.
♦
The integrated battery is empty . Charge the battery .
♦
No connection to the device . Check the connection .
♦
Press the ON/OFF button
charging process .
♦
The charging current of the connected device is too low
(< 80 mA) or too high (> 2 .1 A) .
♦
The internal overcurrent protection may have been triggered .
Disconnect the attached device and connect the micro USB
charging port
section Charging the power bank) .
Afterwards, the power bank can be used again .
NOTE
►
If you cannot solve the problem with the above-mentioned
solutions, please contact the Service Hotline (see section
Service) .
SPB 10.000 B2
once briefly to start the
twice briefly to stop the
go out .
once briefly to start the
to a power source for a short while (see
GB│IE│NI
9
■
│