Troubleshooting - Silvercrest SLQC 3.0 A1 Bedienungsanleitung

NOTE
► Observe the charging status on your connected device .
♦ Disconnect your connected device from the USB charger
once the device has completed charging .
♦ Disconnect the power plug from the power socket if you
no longer require the USB charger .

Troubleshooting

The USB charger is not functioning at all or the operat-
ing LED does not light up white.
♦ Plug the USB charger mains plug into a properly installed
mains power socket .
♦ Please check your house fuses .
The operating LED
USB charger is overloaded or short-circuited.
♦ Immediately disconnect all the connected devices one after
the other until the operating LED
white again . The USB charger is ready for use again .
SLQC 3.0 A1
flashes white or switches off. The
lights up continuously
GB │ IE │ 35 ■