Troubleshooting - Silvercrest SLM 2 A2 Bedienungsanleitung Und Sicherheitshinweise

♦ Now plug the charging device into the 12/24 V
power socket of your car. As a rule this is the
cigarette lighter socket in the dashboard of your
car. Numerous vehicles have a second socket in
the rear seat area or in the boot. 24 Volt batteries
are used, primarily, in trucks or on boats.
♦ The white LED in the housing indicates that the
charger is ready for use. It also lights up when no
mobile phone is connected. Depending on the
vehicle type it is possible that the ignition has to
be switched on first. The charging process begins
immediately and is shown in your mobile phone's
display.
♦ When charging is complete, disconnect the charger
from the 12/24 V connection by pulling on the
bracket. Remove the charger only by holding the
bracket and never pull the cable.
ATTENTION
► Never connect the device without charging your
mobile phone! The device also consumes power
in standby mode and therefore must be discon-
nected from the on-board power supply after
use! If the motor is not running the battery will
otherwise be discharged.

Troubleshooting

A connected device is not charging (the white
LED in the housing does not light up).
♦ No connection to the car's cigarette lighter
socket. Check the connection.
♦ Depending on the vehicle type, it is possible that
the ignition has to be switched on first.
The white LED in the appliance housing goes
out when a device is connected.
♦ The charger is overloaded and will no longer
charge attached devices. The internal overcurrent
protection has been triggered. Disconnect all con-
nected devices from the charger. The white LED
lights up immediately and the charger is ready
for use.
NOTE
If you cannot solve the problem with the above-
mentioned solutions, please contact the Service
Hotline (see section "Service").
GB / IE
- 6 -