Technical Data - FLORABEST FAHE 18 B2 Originalbetriebsanleitung

Technical data

Cordless pruner:
Rated voltage:
Max. rotational speed: 2500 min
No-load speed:
Weight
(with accessories):
Oil tank volume:
Cut length:
Blade:
Saw chain:
Battery:
Type:
Rated voltage:
Capacity:
High-speed
battery charger:
INPUT:
Rated voltage:
Power consumption:
OUTPUT:
Rated voltage:
Charging current:
Charging time:
Fuse (internal):
Protection class:
Noise and vibration data:
Measured values for noise determined in accord-
ance with EN ISO 4871. The A-rated noise level
of the power tool is typically as follows:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
FAHE 18 B2
FAHE 18 B2
18 V
-1
max. 5 m/s
approx. 4.0 kg
65 cm 3
approx. 200 mm
8" Oregon 080NDEA318
Oregon 91P033X
FAHE 18 B2-1
LITHIUM ION
18 V
1.5 Ah
FAHE 18 B2-2
220–240 V ~ , 50 Hz
70 W
18 V
1.8 A
approx. 60 min
T3.15A
3.15 A
II /
72.57 dB(A)
103.20 dB(A)
2.5 dB
Vibration values (vector total of three directions)
determined in accordance with EN 60745:
Vibration
at the front handle: Vibration emission value
a
h
Uncertainty K = 1.5 m/s
Vibration
at the rear handle: Vibration emission value
a
h
Uncertainty K = 1.5 m/s
WARNING!
■ Also reduce the risk due to vibrations, e.g.
the risk of Raynaud's phenomenon, by taking
frequent breaks and rubbing your hands
together!
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance
with a standardised measuring procedure
specified in EN 60745 and can be used to
make equipment comparisons. The specified
vibration emission value can also be used to
make an initial exposure estimate.
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases. There is a risk of underestima-
tion of the vibration load if the power tool is
used regularly in this manner. Try to keep the
vibration loads as low as possible. Meas-
ures to reduce the vibration load are, e.g.
wearing gloves and limiting the working time.
In this case all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool
is switched on but running without load).
= 0.866 m/s 2
2
= 1.138 m/s 2
2
GB
MT
19