Troubleshooting - Dometic CoolFreeze CF16 Bedienungsanleitung

CF11-16-26-O-16s.book Seite 17 Mittwoch, 1. März 2017 4:35 16
CoolFreeze
8

Troubleshooting

Problem
Device does not function,
"POWER" LED does not light
up.
CF11, CF26: The device
does not cool (plug is
inserted, "POWER" LED is
lit).
CF11, CF16: The device
does not cool (plug is
inserted, "POWER" LED
flashes, display is empty).
When operating from the
12/24 V socket (DC socket):
The ignition is on, the device
is not working and the
"POWER" LED is not lit.
Pull the plug out of the
socket and make the
following checks.
CF11: The "ERROR" LED
flashes and the display
shows "ERR1" or "ERR2".
CF16: The display shows an
error message (e.g. "Err1")
and the device does not
cool.
EN
Possible cause Suggested remedy
No voltage is flowing The ignition must be switched on in
from the DC power most vehicles to supply current to
socket in your the on-board power socket.
vehicle.
No voltage present in Try using another plug socket.
the AC voltage
socket.
Defective This can only be repaired by an
compressor. authorised repair centre.
The voltage is too low Check the battery and charge if
at the 12/24 V necessary.
socket.
Check the cables and connections.
The DC socket is If the plug of your cooler becomes
dirty. This results in a very warm in the DC socket, either
poor electrical the socket must be cleaned or the
contact. plug has not been assembled cor-
rectly.
The fuse of the Replace the fuse of the 12/24 V plug
12/24 V plug has (fig. 5 2, page 4).
blown.
The vehicle fuse has Replace the vehicle's 12/24 V socket
blown. fuse (usually 15 A). Please refer to the
operating manual of your vehicle.
Defective device. This can only be repaired by an
authorised repair centre.
The appliance has This can only be repaired by an
switched off due to authorised customer service centre.
an internal fault.
Troubleshooting
17