Switching On The Lights; Using The Jumpstart Feature - ULTIMATE SPEED UPK 10 A1 Originalbetriebsanleitung

Switching on/off:
Switching the device on: move the on/off
„
switch for the power bank with compressor
the 'On' position�
Switching the compressor on: move the on/
„
off switch for the compressor
When the right filling pressure has been
„
achieved, switch the device off: move the on/off
switch for the compressor
Move the on/off switch for the power bank
„
with compressor to the 'Off' position�
8
Disconnecting the connecting valve:
Connection without a valve adapter
„
Open the clamp lever
valve by pressing the clamp lever
15
from the air hose and then pull this off the
14
valve on the inflatable item�
Connecting valve
„
: Pull the valve adapter off the connecting
13
valve on the inflatable item� Open the clamp
lever on the connecting valve
12
the clamp lever away from the air hose
12
and then removing the valve adapter�
Please note: When disconnecting the connect-
ing valve , air can escape from the valve on
15
the inflatable item� Ensure that you remove the
connecting valve as quickly as possible�
15
The pressure gauge is not trade-approved�
Accordingly, after pumping up inflatable items
where the wrong pressure could be dangerous
(e�g� vehicle tyres), always check the pressure at
a service point with a trade-approved device�
Tips for use
The device is not intended for continuous oper-
ation� The device was designed to create air
pressure – not an air flow�
Please do not use the device for more than
7 minutes at a time on items with a large vol-
ume, to avoid overheating and damage to the
device� Then let the device cool down for at
least 15 minutes� We recommend first filling
a large-volume item with air, followed by then
using this device to generate the target pressure�
If you need a higher pressure than 3 bar for
a vehicle tyre, do not use the device for over
3 minutes at a time without stopping� Then let the
to
8
to 'I'�
2
to '0'�
2
13
on the connecting
12
away
12
with valve adapter
15
by pressing
15
14
device cool down for at least 15 minutes�
Air pressure testing
Connect the connecting valve
integrated compressor')�
Read off the air pressure on the pressure gauge
display �
3
Disconnect the connecting valve
'Using the integrated compressor')�
Please note: The pressure gauge is not
trade-approved�
Safety fuse
: If the device becomes overloaded or malfunc-
tions, the safety fuse triggers to protect the
device�
Never install a fuse rated for a
higher trip current� Otherwise
there is a risk of fire!

• Switching on the lights

To switch on the lights
„
the on/off button on the power bank
3 seconds�
Press and hold the power button
„
for 3 seconds to turn the lights off again�
CAUTION! Do not look directly into
the lights
eyes�
Please note: It is not possible to turn on the
lights while the power bank with compressor
is charging�

• Using the jumpstart feature

Check the charge level of the power bank with
compressor � Check that at least 3 indicator
6
lights are illuminated�
5
Connect the jumper cable
jumpstart outlet
7
Connect the red crocodile clip to the positive
terminal on the car battery�
Using the device
(see 'Using the
15
again (see
15
, press and hold
1
4
as this can damage your
1
to the vehicle
11
�
GB / IE / NI 39
for
4
again
6