Intended Use; Features; Technical Specifications - ULTIMATE SPEED UPK 10 A1 Originalbetriebsanleitung

• Intended use

This power bank with compressor (also referred
to in this manual as the 'device' or 'product') is
designed to provide additional support to 12 V
vehicle batteries in diesel and petrol vehicles
experiencing start-up problems caused by batter-
ies that are weak, empty or defective� However,
the power bank with compressor cannot replace
the vehicle battery� If no more than 400 A are
needed for starting (max� peak current), the
power bank lets the user single-handedly start the
vehicle when necessary, without additional help
from a third party� The power bank with com-
pressor is also fitted with a USB port� This means
that mobile phones, satnavs or other USB-ena-
bled devices can also be charged if needed� The
integrated compressor is designed to generate
pressure in tyres (e�g� vehicle and bicycle tyres),
balls and other small-scale inflatable articles� Do
not use the compressor to inflate articles with a
large volume, since it can overheat rapidly in
the absence of back pressure� This power bank
with compressor is not designed for continuous
operation to generate pressure of over 3 bar�
Any other use may cause damage to the device
and expose the user to a risk of serious injury�
The manufacturer is not liable for any injury or
damage resulting from improper use or incorrect
operation� This power bank with compressor is
not suitable for commercial use� Commercial use
will void the guarantee�
This device has been developed for consumer
use and is not suitable for use in a commercial
or industrial environment�
The lamp is not suitable for domestic
room lighting�
The LED bulb is suitable for extreme tem-
peratures below -20 °C�
-20°C

• Features

After unpacking the product, please check that
all of the package contents are present and that
the power bank with compressor is in perfect
condition� Do not use the device if it is defective�
Lamp
1
On/off switch for compressor
2
Pressure gauge with pressure display
3
(not trade-approved)
– In bar: red scale
– In psi: black scale
On/off switch for power bank
4
Indicator lights
5
Power bank with compressor
6
Vehicle jumpstart outlet
7
On/off switch for power bank
8
with compressor
Charging port 15 V
9
USB port 5 V /2 A
10
Jumper cable
11
Clamp lever
12
Valve adapter
13
a+b: for inflatable items
c: for balls
Air hose
14
Connecting valve
15
AC adapter
16
USB cable
17

• Technical specifications

The three individual cells used to construct the
rechargeable battery are connected in series to
produce a total voltage of 3 × 3�7 V = 11�1 V
and a capacity of 4700 mAh� The battery output
produced in this way is the same as the output
from a rechargeable battery with a total capac-
ity of 14000 maH at 3�7 V�
Model:
Battery type:
Battery capacity:
Charge cycles:
Charging time:
Peak current:
Starting current:
Operating temperature: -21 to +55 °C
Voltage:
GB / IE / NI
Introduction
/1 A
UPK 10 A1
lithium-ion
14,000 mAh, 3�7 V
1,500
up to 8 hours
400 A
200 A
12 V
33