Blower Attachment; Use - Cleanmaxx Z 01375 Gebrauchsanleitung

EN

Blower Attachment

The blower attachment can be used to easily remove accumulations of dust and dirt as
well as liquids.

Use

CAUTION!
■ The device must be connected only to a mains socket that has been properly in-
stalled. The socket must also be readily accessible after connection. The mains volt-
age must match the technical data for the device (see the "Technical Data" chapter).
Only use suitable extension cables whose technical data is the same as that of the
device.
■ On no account should the device be used to suck up the following:
– Liquids or wet substances (e. g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e. g. concrete dust), ash or toner
– Pointed, hard objects such as e. g. large pieces of broken glass
■ Never hold the nozzles, the suction tube or the suction hose close to parts of your
body, hair or animals during use. They could become stuck to the device. If the hand-
held vacuum cleaner does become stuck, press the On / Off switch immediately to
switch off the device.
22
1. Remove the back cover of the housing by unscrewing the
cover in the anticlockwise direction.
2. Remove the exhaust air fi lter.
3. Screw on the blower attachment by turning it clockwise.
4. Plug the wide end of the extension hose onto the blower
attachment.