B) Location For Installation - VOLTCRAFT E6 Bedienungsanleitung

• In commercial institutions, the accident prevention regulations of the Employer's
Liability Insurance Association for Electrical Systems and Operating Materials are
to be observed.
• Do not leave packaging material lying around carelessly. It might become a
dangerous toy for children!
• If you are not sure about the correct connection or operation, or if there are any
questions that are not covered by the operating instructions, do not hesitate to
contact our technical support or another specialist.
b) Site of Setup
• The product is intended for dry indoor use only. It must not become damp or wet.
There is danger of a fatal electric shock!
However, do not use the battery charger inside a vehicle.
• Choose a solid, flat, clean and sufficiently large surface for the charger.
Never place the charger on a flammable surface (e.g. carpet, tablecloth). Always
use a suitable, non-flammable, heatproof surface.
Do not place the charger on any valuable furniture surfaces without using suitable
protection. Heat may cause colour or material changes.
Keep the charger away from easily inflammable materials (e.g. curtains, paper),
liquids (e.g. petrol) or gases.
• Avoid direct sun irradiation, strong heat or cold. Keep the charger away from dust
and dirt.
• Avoid operation in direct proximity of strong magnetic or electromagnetic fields,
transmitter aerials or HF generators. This can affect the control electronics.
• Do not place any containers filled with liquid, e.g. vases or plants, on or next to
the product.
When these liquids get into the charger, the charger will be destroyed and there
is great danger of fire or explosion.
In this case, switch off the mains socket to which the charger is connected
entirely (switch off the respective fuse or turn out the fuse. Then deactivate the
associated FI protection switch).
26