Safety Functions; Operation Startup; Mount The Saw Bar; Mount The Saw Chain - FLORABEST FKS 2200 E3 Originalbetriebsanleitung

vices and parts have to be repared or
changed except as noted otherwise in
this manual.

Safety functions

1 Rear grip with hand guard
A
(16)
Protects the hand against branch-
es and boughs in the case of
springing away by the chain.
3 Chain braking lever/hand
guard
Control system, which stops the
saw chain immediately in case
of a spring-back; lever can also
be activated manually; protects
the left hand of the operator if it
slides from the front grip.
The motor cannot be turned on if
the chain brake has engaged.
5 Saw chain with small
spring-back
Helps you to catch spring-backs
with specially developed control
systems.
7 Metal stop claw
Reinforces the stability when
vertical cuts are carried out and
facilitates sawing.
9 Electric motor
Double insulated for safety
reasons.
10 On-off switch with safety
chain brake
On releasing the On/Off switch,
the device immediately switches
off.
11 Switch-on block
The switch-on block must be
released for switching on the
device.
12 Chain catcher
Decreases the danger of injuries
if the chain breaks or if it comes
off.

Operation startup

Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself -– injury hazard!
Before you start up the electric chainsaw,
mount the sword, mount the chain, adjust
the chain, fill up with chain oil and check
the automatic lubrication and chain brake
function.

Mount the saw bar

1. Lay the saw on a flat surface.
F
2. Turn the fastening bolt (14) anti-
clockwise to remove the sprock-
et chain wheel covering (15).
3. To fit the new bar, place the bar
(4) onto the bar bolt (23) with
the tensioning plate pointing out-
wards (24).

Mount the saw chain

1. Spread the chain (5) out into a
G
loop with the cutting edges run-
ning clockwise .
2. Relax the tensioning screw (24)
against the clockwise
direction.
3. Slide the saw chain (5) into the
bar guide groove. To mount the
guide bar (4), raise it to an angle
GB
65