Operating; Assembling The Appliance - Gastroback Design Multi Juicer Bedienungsanleitung

OPERATING

ASSEMBLING THE APPLIANCE

1. Place the filter bowl surround on the motorblock. Locate
the filter bowl surround so that the spout fits through the hole
on the front of the motor base.
2. WARNING:
use any force. Pay attention to the sharp blades on the stain-
less steel micro mesh filter and the feed chute to avoid inju-
ry. Always completely assemble your juicer before you plug
the plug into the power point.
ATTENTION:
Ensure the stainless steel filter basket is clean
before assembling. Any dehumidified left over food on the
basket will block the fine mesh holes. If necessary remove
excess fibre build up (from fruit or vegetables) according to
the instructions ›Care and Cleaning‹.
Align the arrows on the stainless steel filter basket with the
arrows on the motor drive coupling and push down until it
clicks into place. Ensure the stainless steel filter basket is fit-
ted securely inside the integrated pulp container and onto
the motor base.
3. Place the juicer cover over the stainless steel filter on top
of the filter bowl surround. The feed chute has to be positi-
oned in the middle of the filter basket and the pulp spouting
of the cover has to face away from the interlocking safety
arm.
4. Raise the safety locking arm straight up and lock into the
two grooves on either side of the juicer cover. The safety
locking arm should now be in a vertical position and locked
into place on top of the juicer cover.
Handle the units with care and do not
47