Items Supplied; Installation; Blender; Chopper - Silvercrest SSMS 600 D1 Bedienungsanleitung

WARNING! Risk of material
damage
The device is designed for a maximum
operating time of 2 minutes without in-
terruption (see "Operating times" on
page 8).
In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blade is either turning
with difficulty or not turning at all. Pull
out the mains plug and check whether
there is something in the bowl blocking
movement or whether the food is too
tough. Also check whether the device is
assembled correctly.
Fill the chopper only up to the indicated
MAX level (about 500 ml / for liquids
max. 300 ml) to prevent a blocking of
the knives.
Do not use the device for boiling liquids
or during the boiling process and do
not fill boiling hot liquids into the con-
tainer.
Do not use pointed or sharp-edged ob-
jects to remove food.
Only use the original accessories.
Do not use any astringent or abrasive
cleaning agents.

4. Items supplied

1 Motor unit 2
1 Drive cover 3
1 Beater adapter 4
1 Blade insert 5
1 Beater 6
1 Cover/base for chopper 7

1 Chopper 9

1 Blender 10

1 Measuring beaker with cover/base 17
1 Operating instructions

5. Installation

• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.
• Clean the device prior to its first
use (see "Cleaning" on page 11)!
DANGER! Risk of electric
shock! Only plug the mains plug 1
into the wall socket if the motor unit 2
has been connected to the blender.
5.1 Blender
Connecting the blender
(Figure A)
1. Attach the motor unit 2 to the blender
10 in such a way that the attachment
marking 16 is below the symbol
15.
2. Turn the motor unit 2 such that the at-
tachment marking
unit points to the lock marking
The motor unit 2 must engage noticea-
bly.
5.2 Chopper
Mount the chopper
(Figures A + C)
1. Press the slip-resistant cover/base 7
against the chopper 9 from below such
that a tight fit is ensured all around.
2. Place the blade insert 5 on the arbor 8
in the chopper.
3. Fill the chopper 9 with the prepared
food only up to the marked MAX level
(about 500 ml / for liquids max. 300 ml).
4. Set the drive cover 3 on the chopper 9.
5. Attach the motor unit 2 to the drive cov-
er 3 in such a way that the attachment
marking 16 is below the symbol
15.
16 on the motor
15.
7
GB