Settings - IKEA Rengöra Bedienungsanleitung

ENGLISH
Information for test institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com

Settings

Programme selection mode and user
mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
Settings available in the user mode:
• The level of water softener according to
the water hardness.
• Activation or deactivation of the acoustic
signal for the end of a programme.
• Activation or deactivation of the rinse
aid empty notification.
• Activation or deactivation of AutoOpen.
As the appliance stores the saved
settings, there is no need to configure it
before every cycle.
How to set the programme selection mode
The appliance is in programme selection
mode when only the indicator of the
programme
After activation, the appliance is in
programme selection mode by default. If
Water hardness
German degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
is on.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
Write down the product number (PNC) that
is on the rating plate.
not, set the programme selection mode the
following way:
Press and hold simultaneously
until the appliance is in programme
selection mode.
The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
The higher the content of these minerals, the
harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
mmol/l Clarke de-
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
and
Water softener level
10
9
8
7
9