IKEA Rengöra Bedienungsanleitung Seite 19

ENGLISH
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
• The end indicator flashes 1 time in-
termittently.
• Acoustic signal sounds 1 time inter-
mittently.
The appliance does not drain the wa-
ter.
• The end indicator flashes 2 times
intermittently.
• Acoustic signal sounds 2 times in-
termittently.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• Acoustic signal sounds 3 times in-
termittently.
The salt indicator continues to stay on
after the replenishment of the salt
container.
The appliance stops and starts more
times during operation.
Possible cause and solution
• Make sure that the mains plug is connected to
the mains socket.
• Make sure that there is no damaged fuse in
the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
• The appliance has started the procedure to re-
charge the resin inside the water softener. The
duration of the procedure is approximately 5
minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water sup-
ply is not too low. For this information, contact
your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
• Close the water tap and contact an Authorised
Service Centre.
• If after 3 or 4 programmes, the salt indicator
continues to stay on, contact an Authorised
Service Centre.
This can occur when you are using salt that
needs more time to dissolve.
There is no unwanted effect on the perform-
ance of the appliance.
• It is normal. It provides optimal cleaning results
and energy savings.
19