Before First Use - IKEA Rengöra Bedienungsanleitung

ENGLISH
How to deactivate AutoOpen
The appliance must be in the programme
selection mode.
1. Press and hold simultaneously
to enter the user mode.
The indicators: ,
flashing.
2. Press .

Before first use

1. Make sure that the current level of the
water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
After starting a programme, it
may take up to 5 minutes for the
appliance to recharge the resin
in the water softener. It seems
that the appliance is not working.
The washing phase starts only
after this procedure is completed.
The procedure is repeated
periodically.
The salt container
Caution! Use salt designed for
dishwashers only.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in daily use.
and
, and start
The indicators: ,
indicator still flashes.
The indicator shows the current setting.
If on = AutoOpen is on, if off = AutoOpen is
off.
3. Press to change the setting.
4. Press on/off to confirm the setting.
Filling the salt container
1
3
Put 1 litre of water
in the salt container
(only for the first
time).
12
, are off. The
2
4
Put 1 kg of salt in
the salt container.