Set Rotational Speed; Tips And Tricks; Maintenance And Cleaning; Disposal - Parkside PHKS 1350 A1 Betriebsanleitung

Set rotational speed

■ Turn the adjusting wheel
rotational speed (arrow marking ▲)
(1 = lowest rotational speed/6 = highest rota-
tional speed):
Use the following suggested settings or set the rota-
tional speed on the adjusting wheel
Material
Cross cuts & longitudinal cuts in
hard and soft wood (solid wood)
Chipboard, fi bre board
Core board, plywood
Coated and veneered boards
PVC sheets
Acrylic glass sheets, perspex
Aluminium plate
Aluminium profi le
Plaster board
Stone wool board
Cement-bonded particle board

Tips and tricks

■ Avoid damaging the cutting edge of sensitive
materials, e.g. coated chip boards or doors,
by sticking masking tape along the cutting line.
Another benefi t of this is that it is easier to mark
a line on the tape than on a shiny surface. An
even more eff ective method of protecting the
cutting edges is to clamp a thin piece of wood
along the cutting line (this wood is also sawn).
PHKS 1350 A1
to the desired
as required.
Rotational
speed
setting
6
6
6
6
3–5
2-4
4-6
4-6
1-2
1-2
1-2

Maintenance and Cleaning

WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ To clean the casing, use a soft dry cloth.
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or his representative in order to avoid safety
hazards.

Disposal

The packaging consists of environmentally
friendly material. It can be disposed of in
the local recycling containers.
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that worn-
out power tools are collected separately and fed
into an environmentally compatible recycling
process.
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out appliance.
GB
IE
CY
9