Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Advice on use / Bringing into use / Maintenance and cleaning
* This device cannot be used to spray media contain-
ing discrete particles / solids. The abrasive effect
of these media shortens pump and valve life.
Preparing the surface
Q
to be sprayed
The surface to be sprayed must be clean, dry and
free of grease.
R oughen smooth surfaces and remove any
abraded dust.
A lways cover the surrounding area around the
surface to be sprayed. The spray cloud may
contaminate the surrounding area.
Bringing into use
Q
Selecting the nozzle
Q
Nozzle
Nozzle, 0.6 mm
(R6)
8
Nozzle, 0.8 mm
(R8)
8
Cleaning nozzle
11
Nozzle extension
13
Switching ON / OFF
Q
Switching on:
T o start the electrical power tool, press the
ON / OFF switch
3
Switching off:
T o switch off the electrical power tool, release
the ON / OFF switch
Spraying process
Q
1. You can vary the spray by adjusting the regulator
button
(see Fig. D). The spray is correctly
2
10 GB/IE/CY
Use
all paints, varnishes
thick-flowing sprayed media
a thinner, harder spray for
spot-cleaning of surfaces
for spraying into corners
which are difficult to reach
and keep it pressed.
.
3
set when no drops are formed and the gun
produces a fine, consistent spray pattern.
2. Do not switch the device on or off while it is
over the surface to be sprayed. Instead, start
and stop the spraying process approximately
10 cm outside the surface to be sprayed.
NOTE: The distance between the nozzle and
the workpiece depends on the material being
sprayed (approx. 20 to 35 cm spraying dis-
tance, depending on the spray cone and the
desired amount of material to be applied).
U se the device in a horizontal orientation only
(as shown in Fig. D).
C arry out a trial in each case to determine the
most effective spraying distance.
S tart with a longer distance.
3. Spray corners or small decorative details first
using short bursts of spray.
Then go on to the actual spraying process.
4. The spray process should follow the sequence
shown in Fig. E
– keep the spray gun moving parallel to the surface
– Do not incline the spray gun
– Move the spray gun at a constant speed
– Apply the sprayed medium as thinly as possible
– The layer(s) of sprayed medium need(s) to
be allowed to dry for some time before you
apply the next coat (Fig. F) at right angles to
the previous coat.
5. Do not allow the paint cup
pletely while spraying – drops may form!
Maintenance and cleaning
Q
General advice:
1.
fore you carry out any tasks on the spray gun.
Do the same when you take a break from spraying.
2. After each use, spray thinners (in the open
air only – danger of explosion!) or
water through the device.
3. To protect from rust after cleaning, you can
spray sewing machine oil through the device.
4.
THROUGH ELECTRIC SHOCK! Never im-
merse the device in the cleaning medium.
to empty com-
7
Pull out the mains plug be-
DANGER TO LIFE
Werbung
Kapitel
Inhaltsverzeichnis
