Advice On Use; Din-Sec / Viscosity; Preparing The Sprayed Medium - Parkside PFS 100 C2 Betriebsanleitung

General safety advice for electrical power tools / Advice on use
P recise observation of the hazard
warnings, information and data sheets
available from the sprayed medium
manufacturer is essential.
W ear a breathing / dust mask! The inha-
lation of paint mist and solvent vapour is haz-
ardous to health.
W ork in adequately ventilated spaces
only.
W ear protective glasses!
N ever aim the spray at living creatures.
D ANGER OF EXPLOSION! Do not use the
device in environments containing gases, open
flames, fires or gas-operated water heaters.
N O SMOKING!
P aint and solvents (thinners) must
have a flashpoint above 21°C.

Advice on use

Q

DIN-sec / Viscosity

Q
The Parkside paint spray gun PFS 100 C2 can be
used to apply sprayed media with a viscosity up to
80 DIN-sec. Viscosity is determined in a simplified
measuring procedure using the supplied measuring
cup (see Fig. C).
1. Immerse and fill the supplied measuring cup
to the top with the medium to be sprayed.
2. Lift the measuring cup
to be sprayed and let the liquid flow out (see
Figure C).
3. Measure the time in seconds it takes for the
flow of liquid out of the measuring cup to cease.
This time is the "DIN-seconds (DIN-s)" value of
viscosity.
4. If the value is too high, incrementally add and
mix in small quantities of a thinner compatible
with the medium to be sprayed. Proceed in ac-
cordance with the section about "Preparing the
sprayed medium".
5. Remeasure the DIN-seconds value.
Repeat this procedure until a value is obtained
that complies with the values in the table.
12
out of the medium
12

Preparing the sprayed medium

Q
NOTE: Most paints, varnishes etc. in the shops
are intended to be applied by brush not spray. To
achieve the best spraying result, you should prepare
your paint or varnish etc. in accordance with DIN
guidelines to achieve a suitable viscosity (see table).
Use a suitable thinner to achieve the required
thinning of the medium.
N ever exceed the maximum viscosity for the
device. The sprayed medium must not be too
thick for the spraying process, otherwise it
could clog up the device.
E nsure that the sprayed medium and the thinner
are compatible with one another. If the wrong
thinner is used, it can lead to lumps forming
which may clog up the device. Never mix nitro-
thinners with synthetic resin paint.
C onsult the sprayed medium manufacturer's
documentation for information about suitable
thinners (water, solvents).
1. Thoroughly mix the unthinned sprayed medium
and bring it to average room temperature
(20–22 °C).
Do not increase the temperature to change the
viscosity.
2. Add a suitable thinner.
3. Test the viscosity as described above (see Fig. C).
NOTE: Never use nitro-thinners to thin synthetic
resin paint!
Example of
material
Car body paint
Acrylic paint
Synthetic resin paint
Primer
Wood impregnation
Glaze
Hammer finish paint
Emulsion paint
DIN guidance
value
16-20 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
30-35 DIN-sec*
40-80 DIN-sec
GB/IE/CY 9