Enable Edit Mode; Erase A Program; Erase All Programs; Clear A Scene Or Scenes - EuroLite DMX Scene Setter 24/48 Bedienungsanleitung

.
EXAMPLE
Program a 32-step chase with channel 1-24 at full in sequence and assign into Flash button 12 of Page 1.
1 Enable Program mode.
2 Push the MASTER A and B faders to maximum position and the FADE fader to top.
3 Tap the MODE SELECT button to select 1-24 SINGLE mode.
4 Push Channel fader 1 to the top position, its LED lights at full intensity.
5 Tap the RECORD button to program this step into memory.
6 Repeat steps 4 and 5 until you've programmed Channel faders 1-24.
7 Tap the RECORD button causing page 1 LED to light.
8 Tap the FLASH button 13 while holding down the RECORD button, all LEDs will flash indicating you've
programmed the chase into memory.

Enable edit mode

1 Enable Program mode.
2 Use the PAGE button to select the page the program you wish to edit is on.
3 Tap the MODE SELECT button to select CHASE/SCENES mode.
4 Press and hold down the EDIT button.
5 While holding down the EDIT button, tap the FLASH button that corresponds to program you wish to edit.
6 Release the FLASH button, the relevant scene LED should light indicating you are in the Edit mode.

Erase a program

1 Enable Program mode.
2 Use the PAGE button to select the page that the program you wish to erase is on.
3 While holding down the RECORD button, tap the FLASH button (13-24) twice. Release the two buttons. All
LEDs flash, indicating the program is erased.

Erase all programs

1 Press and hold the RECORD button.
2 Tap the FLASH buttons 1, 4, 2 and 3 in sequence while holding the RECORD button. All LEDs will flash,
indicating all programs stored in memory have been erased.

Clear a scene or scenes

1 Enable Program mode.
2 Record a scene or scenes.
If you are not satisfied with the scene or scenes, you may tap the REC CLEAR button while pressing and
3
holding the RECORD button. All LEDs will flash, indicating the scenes have been cleared.

Delete a step or steps

1 Enable Program mode.
Tap the STEP button to scroll to the step you wish to delete.
2
3 Tap the DELETE button when you reach the step you wish to delete. All LEDs will flash briefly indicating the
deletion of the step.
4 Continue steps 2 and 3 until all the unwanted steps have been deleted.
5 Tap the REC EXIT button while pressing and holding down the RECORD button. The scene LED goes out,
indicating the exit of Edit mode.
26 • EN