Dmx Mode; Sound Mode; Auto Run Mode; Master/Slave Operation - EuroLite LED PSU-24V/10 DC Bedienungsanleitung

MODE

DMX MODE

DIMMER MODE

SOUND MODE

AUTO RUN MODE

STATIC COLOR
SELECT MODE
OTHER
MODE

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the LED PSU 24V/4 DC you can find an XLR-jack (DMX Out) and an XLR-plug (DMX
In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the Master device to Automatic or Sound Control Mode and set each Slave device to the same DMX
address or DMX mode.
SET UP button UP/DOWN buttons
Address setting
Channel setting
Ch.32
Ch.48
Select LED tube
Red dimmer
Green dimmer
Blue dimmer
Strobe effect
Select program
Sensitivity
setting
Fade programs
Color change
Speed setting
Select LED tube
Color select
Strobe effect
Display
on/off
Display
normal/inversed
Default
Sets the DMX starting address
~
5 channel mode
7 channel mode
32 channel mode
480 channel mode
/
d-10
individual LED tubes
~
Red intensity
~
Green intensity
~
Blue intensity
~
~ Strobe speed,
slowest,
Select from 24 sound controlled programs
~
Sensitivity setting of the microphone,
~
is the lowest level,
highest level
Select from 24 built-in fade programs
~
Select from 24 built-in color change
~
programs
Adjust the program speed
~
/
S-10
LED tubes 1 - 10
~
Static color selection
~
~ Strobe speed,
slowest,
Display always on
Display off
Display normal
Display inversed
Return to factory settings
23/28
Function
all LED tubes,
is off,
is fastest
all LED tubes,
is off,
is fastest
00065031, Version 1.1
d-10
~
is
is the
S-10
~
is