Insert A Step Or Steps; Modify A Step Or Steps - EuroLite DMX Scene Setter 24/48 Bedienungsanleitung

.
EXAMPLE
Delete the 3rd step of the program on Flash button 13 on Page 2.
1 Enable Program mode.
2 Tap the MODE SELECT button to select CHASE/SCENES mode.
3 Tap the PAGE button until Page 2 LED lights.
4 Tap the FLASH button 13 while pressing and down the EDIT button. The scene LED lights.
5 Tap the STEP button to scroll to the third step.
6 Tap the DELETE button to delete the step.
7 Tap the REC EXIT button while pressing and holding down the RECORD button to exit Edit mode.

Insert a step or steps

1 Record a scene or scenes you wish to insert.
2 Be sure you're in CHASE/SCENES mode. Then enter the Edit mode.
3 Tap the STEP button to scroll to the step which you wish to insert before. You may read the step from the
display.
4 Tap the INSERT button to insert the step you've created. All LEDs will flash, indicating the step is inserted.
5 Tap the REC EXIT button while pressing and holding down the RECORD button. The scene LED goes out,
indicating the exit of Edit mode.
.
EXAMPLE
Insert a step with channels 1-12 fully on at a time between step 4 and 5 of program 35.
1 Enable Program mode.
2 Push Channel faders 1-12 to the top and record the scene as a step.
Tap the MODE SELECT button to select CHASE/SCENES mode.
3
4 Tap the PAGE button until Page 2 LED lights.
Tap the FLASH button 23 while holding down the EDIT button, the corresponding scene LED lights.
5
6 Tap the STEP button to scroll to the step 4.
7 Tap the INSERT button to insert the scene you've created before.

Modify a step or steps

1 Enter Edit mode.
2 Tap the STEP button to scroll to the step you wish to modify.
3 Press and hold the UP button if you want to raise the intensity. If you want to lower the intensity, press and
hold down the DOWN button.
4 While holding down the UP or DOWN button, tap the FLASH button corresponding to the DMX channel of the
scene you wish to modify until you reach the desired intensity value read from the display. Then you may tap
the FLASH buttons until you are satisfied with the new scene.
5 Repeat steps 2, 3 and 4 until all the steps have been modified.
6 Exit Edit mode. Tap the REC EXIT button while pressing and holding down the RECORD button. The scene
LED goes out, indicating the exit of Edit mode.
27 • EN