ATIKA 2300 Originalbetriebsanleitung Seite 16

O p e r a t i o n a l f a u l
O p e r a t i o n a l f a u l
Before each fault elimination:
− Switch off device.
− Wait for standstill of the device.
− Pull out mains plug.
Fault
Motor does not start
Motor hums but does not start
Shredding material is not drawn
into the shredder
Shredding material not cut cleanly. Fixed counter blade not adequately
Device starts but blocks under as
slight load and switches off via
protective motor switch.
t s
t s
Possible cause
No power supply
Mains cable defective
Machine overloaded (motor protection)
Retaining basket unlocked
(safety cut-out device of the retaining
basket has tripped)
Cutting roller blocked
Capacitor faulty
The cutting roller is running in reverse.
Wrong switch position
Shredding material caught in funnel
Shredding material too soft or wet
Cutting roller worn
adjusted.
Extension cable too long or cross-
section to small.
Socket too far from mains supply and
cross-section of mains cable too small.
Remedy
Check fuses
have these checked (electrician)
Allow the device to cool down.
Press the
1. reset button (motor protection)
2. green button I to restart.
Lock the retaining basket
Switch off the device.
Turn the direction of rotation selector switch into
position . Switch on device until the jam has been
cleared. Switch device off again. Turn back the direc-
tion of rotation selector switch to position .
Bring machine to manufacturer or authorised work-
shop for repair
Switch off device and switch over direction of rotation
selector switch.
Switch off device. Switch the direction of rotation
selector switch into position . Switch on device to
release the material to be shredded, remove any
foreign matter.
Switch off device again. To continue work, place the
direction of rotation selector switch back into position
.
Push down with a branch and shred
Adjust fixed counter blade as described under „ad-
justing the fixed counter blade". In case of severe
wear, replace cutting roller.
Adjust fixed counter blade.
Extension cable at least 1.5 mm², maximum 25 m
long. If a longer cable is used, minimum cross-
section 2.5 mm².
15