Querying The Status Information (Getstatus) - Guntermann & Drunck FIBREVision Installationsanleitung

Monitoring
The following table shows the events logged by the KVM extendeder:
Notification
DVI-Plug connected
DVI-Plug disconnected
DVI-Signal loss
DVI-Signal ok
Monitor connected
Monitor disconnected
Remote-Unit Offline
Remote-Unit Online
Screen Freezing active
Screen Freezing inactive
USB-Emulation active
USB-Emulation inactive

Querying the status information (GETSTATUS)

The command can be used to query various status information of the
GETSTATUS
KVM extender.
Command:
<GETSTATUS ReqID="123"/>
Exemplary answer of the KVM extender:
<STATUS Ver="1" ReqID="123">
<FreezingActive>NO</FreezingActive>
<LocalVideoInput>OK</LocalVideoInput>
<StatusLocal>OK</StatusLocal>
<StatusRemote>FAIL</StatusRemote>
<USBStatus Mode="TRANS">OK</USBStatus>
</STATUS>
44 · G&D FIBREVision
Event
connected DVI cable (computer side)
disconnected DVI cable (computer side)
no DVI signal
detected DVI signal
established cable connection to monitor
no cable connection to monitor
interrupted connection to user module (CON)
established connection to user module (CON)
active Freeze function
inactive Freeze function
established USB connection to computer
interrupted USB connection to computer