Changing The Videomode Of The User Consoles - Guntermann & Drunck FIBREVision Installationsanleitung

Configuration

Changing the videomode of the user consoles

NOTE: This function can only be (de)activated in the setup menu.
In the standard configuration of the FIBREVision system, the computer's video sig-
nal is put out at the monitor of the active console and at the monitor of the concur-
rent console.
By applying the Changing the videomode of the user consoles function, the video signal at
the concurrent user's monitor is disabled if the user enters data.
After finishing your inputs, the monitor at the concurrent console is reactivated after
the automatic input lock has elapsed or the permanent input lock has been deacti-
vated.
How to select the video mode of a user console:
1. Use the terminal emulator to establish the connection to the FIBREVision
system.
2. Use the arrow
3. Use the arrow
the local console.
Use the arrow
the remote console.
4. Press the Space
Always On
Switch Off
5. Press the Q
6. Press the S
Related topics:
 Changing the timeout of the automatic input lock on page 28
 Authorising permanent console access on page 29
30 · G&D FIBREVision
keys to select the
keys to select the
keys to select the
key (repeatedly) to select your video mode:
 always display the video signal of the concurrent user
 switch off video signal for inputs of the other user
key to leave the Console Access menu.
key to save your settings.
Console Access row and press the
Videomode CPU row to change this setting for
Videomode CON row to change this setting for
Enter key.