Technical Information - IKEA SMAKLIG Anleitung

ENGLISH
Problem
symbol plus a number
appears on the heat setting
display.
lights up on the heat
setting display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.

Technical information

Rating Plate
Made in Germany
© Inter IKEA Systems B.V. 1999
202.228.30
21552
PQM
The graphic above represents the rating
plate of the appliance (without serial num-
ber which is generated dynamically during
the production process), which is located at
its underneath surface of the casing.
Possible cause
Electronics fault.
Overheating protection for
the cooking zone operates.
by a registered engineer, the visit from the
customer service technician or dealer may
not take place free of charge, even during
the warranty period.
Model SMAKLIG Typ 58 GAD DC AU 7,4kW
PNC 949 594 315 00 S NO ............... 220V-240V AC 50-60 Hz
Dear Customer, please apply here aside
the sticker you can find in the dedicate
plastic bag inserted inside the hob packag-
ing. This will allow us to assist you better, by
identifying precisely your hob, in case you
will need in future our assistance. Thank you
for your help!
Disconnect the appliance
from the electrical supply for
a few minutes (Take the fuse
out of the house's electric
system) If after switching on
again,
again, call the after sales
service.
Switch off the appliance. Re-
move the hot cookware. Af-
ter approximately 30 sec-
onds switch on the cooking
zone again.
appear, residual heat indi-
cator can stay. Cool down
the cookware and check it
with the section Cookware
for the induction cooking
zone.
If you operated the appliance wrongly,
or the installation was not carried out
11
Remedy
is displayed
should dis-
7,4kW Induction
230 V
DGT