Connecting The Water Supply - Stihl RE 661 Gebrauchsanleitung

Disconnect the high-pressure hose
3
2
4
Release the brake (1) on the hose
N
reel
To release the hose reel brake, pull the
lever (1) downward.
To lock the brake, press the lever (1)
firmly upward until the hose reel is
locked.
Unroll the high-pressure hose (2)
N
Unscrew the union nut (3)
N
Open the hose guide (4)
N
Pull high-pressure hose (2) off of
N
connector
Connecting the high-pressure hose
Push the high-pressure hose (2)
N
onto the connector of the hose reel
Attach union nut (3) and screw it on
N
and tighten by hand
Push the high-pressure hose into
N
the hose guide (4) and close the
hose guide.
Release the brake (1) on the hose
N
reel
Wind up the high-pressure hose (2)
N
RE 661, RE 661 PLUS, RE 961 PLUS
High-pressure hose and spray gun
Connection
1
Push the high-pressure hose (1)
N
onto the connector (2)
Attach union nut (3) and screw it on
N
and tighten by hand
Disconnection
Push the coupling (4) in the
N
direction of the arrow and hold it
Loosen the union nut (3) and
N
unscrew it from the connector in the
direction of the arrow
Connecting the water
supply
Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other particles from entering
the machine.
2
N
3
1
N
N
4
3
Connect hose (3/4" diameter)
Mesh the jaws with each other and
turn right as far as possible
Turn on the tap – water tank fills with
water
Do not use dirty water. When the
water quality is poor (e. g., flowing
sand), use a water filter in the
water intake – see "Special
accessories".
English
45