Connecting The Water Supply - Stihl RE 362 Gebrauchsanleitung

English
High-pressure hose and spray gun
Fitting
2
3
1
Push the high-pressure hose (1)
N
onto the connector (2)
Attach union nut (3) and screw it on
N
and tighten by hand
Removing
4
3
Push the coupling (4) in the
N
direction of the arrow and hold it
Loosen the union nut (3) and
N
unscrew it from the connector in the
direction of the arrow
High-pressure hose extension
As a rule, always use only one high-
pressure hose extension – see "Special
accessories"
48

Connecting the water supply

Connecting the water hose
N
Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other particles from entering
the machine and to purge the air from
the water hose.
Diameter of water
hose: 3/4"
Length of water hose: min. 10 m (to
absorb pres-
sure surges)
max. 25 m
Mesh the jaws with each other and
N
turn right as far as possible
Turn on water supply
N
To vent the system:
Actuate the spray gun (without
N
spray lance mounted) until a
uniform water jet emerges
Connection to the drinking water main
When hooking up to the drinking water
main, a backflow preventer must be
installed between the water tap and the
hose. The design of the backflow
preventer must comply with the
applicable country-specific regulations.
If drinking water has passed through the
backflow preventer, it can no longer be
regarded as drinking water.
Follow the rules laid down by the local
water supply company to prevent water
flowing back from the high-pressure
cleaner into the drinking water main.
RE 362, RE 362 PLUS, RE 462, RE 462 PLUS