Fitting, Removing High-Pressure Hose; Connecting The Water Supply - Stihl RE 232 Gebrauchsanleitung

Fitting, removing high-
pressure hose
Machine without hose reel
Connecting the high-pressure hose
1
2
Push high-pressure hose onto the
N
connector (1)
Fit and attach the union nut (2) and
N
tighten it by hand
Disconnecting the high-pressure hose
Unscrew the union nut (2)
N
Pull high-pressure hose off of
N
connector (1)
Machine with hose reel
The high-pressure hose is already
connected.
RE 232, RE 272 PLUS, RE 282 PLUS
High-pressure hose and spray gun
Fitting
2
3
1
Push the high-pressure hose (1)
N
onto the connector (2)
Fit and attach the union nut (3) and
N
tighten it by hand
Removing
4
3
Push the coupling (4) in the
N
direction of the arrow and hold it
Loosen the union nut (3) and
N
unscrew it from the connector in the
direction of the arrow
High-pressure hose extension
Always use only one high-pressure hose
extension (special accessory).
Connect the high-pressure hose
N
extension between the high-
pressure hose and spray gun.

Connecting the water supply

Connecting the water hose
N
Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other particles from entering
the machine and to purge the air from
the water hose.
Diameter of water
hose: 3/4"
Length of water hose: min. 10 m (to
absorb pres-
sure surges)
max. 25 m
RE 232
2
1
RE 272
RE 282
2
1
Push the coupling (1) on to the hose
N
connector (2)
Turn on water supply
N
To vent the system:
English
43