Private Exchanges/T-Net; R" Button On Private Exchanges; R" Button And The Deutsche Telekom T-Net; Inserting An Automatic Pause - AUDIOLINE DECT 4800 Bedienungsanleitung

7

Private exchanges/T-NET

You can use the "R" signal button
when using DEUTSCHE TELEKOM's T-Net functions.
7.1

"R" Button on private exchanges

If you have connected your telephone to a private exchange, you can use all the
facilities such as call transfer, automatic recall, etc. The "R" signal button gives you
access to these facilities. The FLASH time "100ms" will be required on a private
exchange (Adjustment, see 8.7). You can find out from the dealer from whom the
equipment was purchased whether your telephone will work on your private
exchange without any problems.
7.2

"R" Button and the DEUTSCHE TELEKOM T-Net

Your telephone supports the most important DEUTSCHE TELEKOM added value
functions (e.g. brokering, call waiting, three-way conference, etc.). The T-Net works
using the "FLASH 300ms" setting. (Adjustment, see 8.7). Please contact
DEUTSCHE TELEKOM to gain access to T-Net functions.
7.3

Inserting an automatic pause

With some private exchanges, it is necessary to dial a certain number (e.g. "9" or
"0") in order, after a short pause, to obtain a dialling tone for an outside line on the
extension.
An automatic dialling pause of ca. 3 seconds can be incorporated into the number.
When entering the number, hold the
the d indicator appears in the display. Then enter the remaining digits of the phone
number. You can, of course, also store this pause with numbers in the phone book.
84
- Private exchanges /T-NET -
on your telephone on private exchanges and
button pressed at the required point until