Startup / Operation - BOMANN VS 2195 Bedienungsanleitung

Reverse the door opening Reverse the door opening
Reverse the door opening Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE: : : : NOTE
NOTE NOTE
• When installing, ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Loosen the screws at
the appliance rear and
remove the top cover.
• Dismount the upper door hinge and
the opposite screws. Open the ap-
pliance door a little and lift it out..
Place the appliance door safely
aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the
feet and dismount the lower
door hinge.
• Attach the door hinge at the
other appliance side, after
you have unscrewed the
hinge pin (1) and used it at
the other hinge side (2).
Turn in the feet accordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Transfer the upper door hinge
and the screws on the respective
opposite appliance site. Put the
hinge pin in the hole of the appliance door and
tighten the screws.
• Replace the top cover,
which you have removed
at the beginning and
screw wrench, Phillips screw-
tight the screws.
• Check if the door is aligned vertically and horizon-
tally optimally so that the smooth opening and
closing of the door is guaranteed.
• Dismount the door handle and attach it to the
corresponding other door outer side. Refer to the
instructions in "Assembling the door handle".
Transfer the cover caps on the exposed holes to
the respective other door outer side.

Startup / Operation

Startup / Operation Startup / Operation Startup / Operation
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION: : : : CAUTION
CAUTION CAUTION
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
following section "Settings".
Settings Settings
Settings Settings
Setting [0] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [1–7] regulates the different values
of the internal temperature.
Setting 0 Setting 0 Setting 0 Setting 0 Setting 1 Setting 1 Setting 1 Setting 1
Off state Lowest setting
(warmest inside
temperature)
18
Setting 7 Setting 7 Setting 7 Setting 7
Highest setting
(coldest inside tem-
perature)