Changing Channels - Pioneer PDP-435FDE Bedienungsanleitung

07 Watching TV
Plasma Display/Media Receiver status indicators
Plasma Display
POWER ON STANDBY
Flashing
For other than the above, see "Troubleshooting" on page 45.
CHANNEL +/–
22
En
Indicator Status
Media Receiver
POWER ON STANDBY
Flashing
Plasma Display
(right view)
Channel display
8
AAA
STEREO
10:00
STANDARD
FULL
System Status
Power to the Plasma Display and Media Receiver is off. Or the power
cords have been disconnected.
Power to the system is on.
The system is in the standby mode.
Power to the Media Receiver is off. Or the power cord has been discon-
nected from the Media Receiver.
Power to the Plasma Display is off. Or the power cord has been discon-
nected from the Plasma Display.

Changing channels

Using P +/– on the remote control unit
• Press P + to increase the channel number.
• Press P – to decrease the channel number.
When viewing Teletext information:
• Press P + to increase the page number.
• Press P – to decrease the page number.
• CHANNEL +/– on the Plasma Display operates the same
as P +/P –.
• P +/P – cannot pick up channels that are set to skip.
Using 0 – 9 on the remote control unit
Select channels directly by pressing buttons 0 to 9.
EXAMPLE
• To select channel 2 (1-digit channel), press 2.
• To select channel 12 (2-digit channel), press 1, followed by
2.
When viewing Teletext information:
View a page directly which is 3-digit page number from 100 to
899 by pressing buttons 0 to 9. See page 43.
• In the standby mode, when you press 0, the power turns on
and the on-screen image comes from the INPUT 1 source.
Or, when you press any button from 1 to 9, a TV image
displays.