Watching Tv; Turning The Power On; Plasma Television Status Indicators; Changing Channels - Pioneer PDP-4270XA Bedienungsanleitung

Watching TV

Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner must be
set up. See Setting up TV channels on page 25 for how to do this.

Turning the power on

• To turn on the system, press POWER on the bottom-left of
the front of the plasma television.
The POWER ON indicator lights blue.
• To switch the system back into standby, press  on the
remote control unit or STANDBY/ON on the plasma television's
control panel on the right-hand side.
The STANDBY indicator lights red.
• You can then turn on the system again by pressing  or 0 to 9 on
the remote control or STANDBY/ON on the plasma television. If
you press 0 on the remote control unit, images come from the
INPUT 1 source. If you press 1 to 9, TV images display.
• You can also press POWER on the plasma television to turn off the
system. However, you cannot then turn on the system again by
pressing the buttons on the remote control unit or STANDBY/ON
on the plasma television.
Note
• When the system is placed into standby mode, the main power
flow is cut and the system is no longer fully operational. A minute
flow of power feeds the system to maintain operational readiness.
• If you are not going to use the plasma television for a long period
of time, be sure to remove the power cord from the power outlet.

Plasma television status indicators

The table below shows the operational status of the plasma television.
You can check the current status of the system with the indicators on
the plasma television.
Indicator status
POWER ON STANDBY
The power cord of the plasma television has been
disconnected. Or, the power cord of the plasma
television has been connected but the POWER button
of the plasma television is off.
Power to the system is on.
The system is in the standby mode.
For other than the above, see Troubleshooting on page 44.

Changing channels

Use the remote control or the control panel on the right-hand side of
the plasma television to change channels.
Channel display
System status
8
AAA
STEREO
10:00
STANDARD
FULL
06
21
En