Keeping Liquids And Soups Warm - Silvercrest SEAD 1800 B1 - IAN 89015 Bedienungsanleitung

RP89015 Einkochautomat LB1 Seite 70 Freitag, 22. Februar 2013 4:23 16
8. Place the jars you have prepared in the
container 3.
Note: The jars can be arranged in the
container 3 in two layers.
9. Add water to the container 3 so that the
jars on top are standing about 3/4 in
water.
10.Place the lid 1 on the container 3.
11. Set the temperature and operating time
(see "6.1 Adjusting settings, switching
on and off" on
"8. Operating times and temperatures"
on page 73).
12. Start the preserving process by pressing
the start/stop button
"6.1 Adjusting settings, switching on
and off" on page 68).
13.As soon as the operating time selected
ends, place a heat-resistant vessel under
the tap 5.
14.Press the lever 4 to let the water out of
the container 3.
15.Allow the jars to cool down before
taking them out of the container 3 .
Note: Preserving jars that are still warm
are sensitive to draughts. Where
possible, you should therefore leave
them in the container 3 until they have
cooled right down. Should you need the
appliance beforehand, you can take the
warm jars out, place them on a towel
and cover them up with another towel
until they have cooled right down.
16.Label the jars with the contents and the
date you preserved them.
17. Store your preserves in a dry, dark, cool
place, and they will then keep for up to
a year.
70

6.3 Keeping liquids and soups warm

This appliance is also ideal for keeping
mulled wine, cocoa, soups and hot pots
warm.
Warning! Make sure there is never too
much liquid in the appliance. The level of
liquid must always be below "MAX". If there
is too much liquid, the appliance might
overflow.
1. Add the liquid to the container 3.
page 68 and
2. Place the lid 1 on the container 3.
3. Turn
temperature 6 to the temperature you
require.
6 (see
– The temperature is increased in
– A signal sounds every 5 °C;
– The temperature selected is shown on
4. Do not select the time but press the
rotary "TIMER" knob 7.
– The display will show a horizontal "8".
5. Press the start/stop button 6.
– The appliance will begin to heat up;
– As soon as the temperature selected is
– The appliance will remain hot until you
6. Stir the liquid regularly to distribute the
heat evenly and make sure it does not
get stuck to the bottom .
7. Clear liquids not containing any solid
particles can be drawn off using the
tap 5. To do so, press down the lever 4.
Note: If you do not want to keep the
tap lever 4 held down to draw of large
volumes of liquid, you can move the tap
lever 4 up vertically.
the rotary knob
increments of 1 °C;
the display for
selection 10.
reached, signals will sound;
press the start/stop button 6 again.
for the
temperature