Manual Preset; Storing Stations In Memory; Fm Station Automatic Preset: Ssm - JVC kd-lh1000r Bedienungsanleitung

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations

FM station automatic preset: SSM

You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you want
to store FM stations into.
Each time you press the
button, the band changes
as follows:
FM1 FM2
2
Press and hold both buttons for more
than 2 seconds.
"–SSM–" appears, then disappears when
automatic preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons —
No.1 (lowest frequency) to No.6 (highest frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.

Manual preset

You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
1
2
FM3 AM
3
preset number 1 of the FM1 band.
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the
button, the band changes
as follows:
FM1 FM2
Tune in to a station (in this example,
of 88.3 MHz).
Press and hold the number button (in
this example, 1) for more than 2
seconds.
The display pattern automatically changes to the
small animation display and the preset number
flashes (then the previous display pattern resumes).
CONTINUED ON THE NEXT PAGE
FM3 AM
Press ¢
to
tune in to stations
of higher
frequencies.
Press 4
to
tune in to stations
of lower
frequencies.
11