Charging Process - FLORABEST FGS 3.6 A1 Originalbetriebsanleitung

GB IE
mains before closing or open-
ing connection to the battery /
power tool / device. This ensures
that the battery and charger are not
damaged.
Keep the charger clean and
•
away from wet and rain. Do
not use the charger outdoors.
Dirt and the entry of water increase the
risk of electric shock.
Operate the charger only with
•
the appropriate original bat-
teries. Charging other batteries may
result in injuries and risk of fire.
Avoid mechanical damage to
•
the charger. This can result in inter-
nal short circuits.
Do not operate the charger on a
•
combustible surface (e.g. paper,
textiles). Risk of fire due to heating
during charging.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the charger to charge non-
rechargeable batteries.

Charging process

Do not expose the battery to
extreme conditions such as
heat and impact. There is a
risk of injury from leaking
electrolyte solution! In case
of contact, rinse with water
or neutraliser and consult a
doctor if contact has occurred
with eyes etc.
12
Charge the battery only in dry
areas.
Do not switch on the device
while charging it and make
sure that the safety key (
has been removed.
There is a risk of injury from
electric shock.
Ensure that the equipment is charged
for no longer than 3-5 hours without
interruption. The battery and equip-
ment could be damaged and they
consume energy unnecessarily in
case of longer charging time. Over-
charging invalidates the guarantee.
• Before initial use, charge the battery in-
stalled in the equipment. Do not charge
the battery for several short periods in
succession.
• Use the charger supplied to charge the
Li-ion battery installed in the equipment.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable
safety information as well as the regula-
tions and directions for environmental
protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
1. Remove the safety key (7).
2. Connect the charger cable plug
(17) with the charger socket on
the tool (5).
3. Connect the power supply unit
(16) to a socket.
The charging indicator (6) lights
up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging time
is max. 3 – 5 hours.
7)