Herunterladen Inhalt Inhalt Diese Seite drucken

Charging The Battery; Removing / Inserting The Battery; Recharging The Battery - FLORABEST IAN 273039 Originalbetriebsanleitung

Akku-rasentrimmer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GB
IE

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry room
only.
Prior to attaching the charger, check
that the battery's outer surface is
clean and dry.
There is a risk of injury due to elec-
tric shock.
Only use the original charger from
the package to charge the battery.
Mind not to charge the appliance
for more than 5 hours at a time. If
you do, the battery and the appli-
ance may be damaged and longer
charging times would be a waste
of energy. Excessive charging will
void the warranty.
Charge the battery before the first
time of use. Do not briefly charge
the battery several time in a row.
Recharge the battery when you no-
tice that the appliance is becoming
slower.
If a fully recharged battery lasts
for considerably shorter operating
times, the battery is used up and
needs to be replaced. Only use an
OEM spare battery available from
our Customer Service.
Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
12
The warranty excludes all defects
caused by improper handling.
Removing / inserting the
battery
1. To remove the battery (16) from
the appliance, press the release
button (17) on the battery and
pull out the battery.
2. To insert the battery (16), place
it on the guide track (20) and
push it back into the appliance.
It will audibly snap in.
Do not insert the battery until
the appliance is fully assem-
bled. Risk of injury!

Recharging the battery

Recharge the battery (
last charge state indicator LED (
lights up red.
One LED at the charging status indi-
cator (
18) of the battery (
LED flashes green during the char-
ging process. A green LED for each
preloaded section of the batteries
(
16). If all three LED'S of the indi-
cating charging status (
up green, the battery (
charged.
1. Remove the battery (16) from the
appliance, as necessary.
2. Inser the battery (16) in the char-
ging compartment of the battery
charger (19). It will audibly snap
in.
3. Plug the battery charger (19)
into a mains outlet.
16) when the
18)
16)
18) lights
16) is fully

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Fat 18 b3

Inhaltsverzeichnis